10 • Raven ST
Ride Height
Ride height is an adjustment that affects the way your car jumps, turns, and
goes through bumps. To check the ride height, drop one end of the truck
from about 6 inches onto a flat surface. Once the truck settles into position
check to see that the front arms are equal and level to the ground. When
looking at the rear, it should be set so that both dogbones are level to the
ground. Lowering the front ride height will increase the amount of steering;
lowering the rear will increase traction but decrease steering.
Battery Placement
The battery position in your Raven™ can be adjusted by moving the two
foam blocks provided with your kit. Moving the battery forward will increase
steering. Moving the battery to the rear will increase traction.
Slipper Adjustment
The slipper clutch helps eliminate parts breakage in the transmission and
also aids drivers in low traction conditions coming off corners and landing
jumps. To adjust the slipper tension, simply loosen or tighten the nut on
the outside of the spur gear. Set your vehicle on the ground and punch the
throttle. The slipper should slip for one to two feet at most. If it doesn’t slip
for at least one foot, back the nut off 1/8 of a turn and retry.
Содержание Raven ST
Страница 13: ...Raven ST 13 Note All screws are included with Key 49 Raven Screw Set ...
Страница 14: ...14 Raven ST Note All screws are included with Key 49 Raven Screw Set ...
Страница 15: ...Raven ST 15 Note All screws are included with Key 49 Raven Screw Set ...
Страница 16: ... 2005 Horizon Hobby Inc 4105 Fieldstone Road Champaign Illinois 61822 877 504 0233 www horizonhobby com 8438 ...