30
Figure 21
Step 13:
Step 14:
Now place the edge cover (#E) on the edge of the
jumping mat (#C) so that the basic structure
and the metal springs (#D2) are covered. The
seams of the edge cover should be at the same
level as the protective net holder (Fig. 20).
IMPORTANT:
Make sure that the safety instructions
on the edge cover are at the entrance and exit of
the protective net (Fig. 21). These must be read and
understood before each use. To increase security,
the edge cover can also be attached to the frame
structure with additional loops, which are located on
the underside of the cover.
Figure 20
Open the zip of the entrance and exit on the pro-
tective net (#D1) and slide this first on the edge of
the jumping mat (#C). Now step onto the jumping
mat and begin to pull the six fiberglass rods (#D3)
through the nylon edges provided at the upper
end of the protective net. Make sure you lay out
the poles in the same direction. Now put them
together by guiding the fiberglass rods through the
caps attached in step 6 above the protective net
holder and using the metal connecting pieces atta-
ched to the fiberglass rods (Fig. 22), which should
be at the same level as the protective net holders
(Fig. 23).
Note:
If this proves to be difficult, pull the protec-
tive net holder with a little force in the direction of
the jumping mat, in order to be able to push the
fiberglass rods better through the openings and
connect them. We recommend doing this step
with a second person.
Figure 22
Figure 23
