5
3. ASSEMBLE THE PRODUCT
STEP 1
Install the Boom Assembly
(a) Remove mast assembly and boom assembly from packaging. Use care
while handeling the assembly; these sections are connected by a cable.
(b) Lay mast assembly on ground. Slide boom assembly down onto mast
tube, align bolt holes.
(c) Insert bolts, washers, and pins as shown. Tighten bolts and insert snap
rings (Note: the hardware shown below is not to scale.)
(d) Check cable to ensure it is properly seated in the pulley groves.
IC1046
MAST ASSEMBLY
IC1065
IC01-023
IC1048
IC1047
IC1059
BOOM ASSEMBLY
1/4" Lock
Washer
IC1046
4x
1/4-20 x 3/4"
BHCS
IC1065
1x
Clevis Pin
Ø1/4 x 3/4"
IC1047
4x
IC01-023
1x
Boom
Shear Pin
IC1048
4x
1/4" SAE
Washer
IC1059
2x
Ø3/8
E-Clip
