JUNIOR HACK ATTACK
™
BASEBALL PITCHING MACHINE
SPORTS ATTACK, LLC.
•
800-717-4251
•
sportsattack.com
12
COMPONENT REPLACEMENT
(cont’d)
CONTROLLER REPLACEMENT
1. Turn the on/off switch “OFF” and unplug the power cord.
2. Remove four screws holding controller faceplate into main casting. Note the position of
the main power and motor wires on the controller, then disconnect the wires. See Figure
12 on page 12 for the three motor wires. See Figure 13 on page 12 for the main power
cord wires.
Reassemble in reverse order.
Be sure wires are correctly reinstalled. Motor wire connectors are different sizes. Be sure
they are installed on the correct size terminal. See Figure 10 for the motor wires and
Figure 13 for the power cord wire.
Component Replacement
Figure 11
Wiring diagram from the control board side
Figure 12
Wiring diagram for all three motors.
Right Motor
Circuit Breaker
Bottom Motor
Left Motor
CONNECTING WIRES
Motor
Black
White
Wire
Wire
Right
A-
A+
Left
A+
A-
Bottom
A-
A+
Black motor wires are
3
/
16
” female
disconnect and white wires are
1
/
4
” female disconnect.
#3
#1
#2
Figure 13
WIRING
POWER CORD
White or Blue Wire (1)
To middle male terminal marked “N.”
Black or Brown Wire (2)
To circuit breaker.
Green Wire (3)
Grounds to machine/motor.
MOTOR WIRE LEADS
Black 3/16” wide connectors.
White 1/4” wide connectors.
Black Wire (2) connects to A-
on circuit board.
White Wire (2) connects to A+
on circuit board.
CONTROLLER
Black Wire (2) 2 PR jumper wire:
- 1 from on/off switch to
circuit breaker
- 1 from on/off switch to
circuit board terminal “L”.
