SportDOG Little Dog Sport Trainer 105, Руководство пользователя

Страница: 3 / 8

Step I — Insert Batteries
Receiver for the Little Dog Sport Trainer 105
• Use a small Philips screwdriver to remove the two screws on the receiver.
• Press the battery door up in the direction of the arrows on the door. It will move up
slightly and the door will release.
• Insert two, 3-volt lithium CR2032 batteries per the diagram on the receiver.
• Replace the battery door. Check to ensure the gasket is in place and clean.
• Tighten the screws. Do not over tighten.
Receiver for the Big Dog Sport Trainer 105S
• Use a small Philips screwdriver to remove the two
screws on the receiver and remove the battery door.
• Remove the battery door.
• Insert two, 3-volt lithium CR2032 batteries per the
diagram on the battery door.
• Replace the battery door. Check to ensure o-ring is
in place and clean. Press and snap into the receiver.
• Tighten the screws, being careful not to overtighten.
Hand Held Transmitter for Both Remote Trainers.
• Pull the battery door open at the top.
• Insert the 9V battery according to the diagram in the
transmitter. It will only fit one way.
• Replace the battery door by positioning the bottom
edge and snapping door into place.
• Activate the transmitter by pressing either button.
or Ensure the receiver collar is not on the
dog. The transmitter LED will light.
3
Positive “+” polarity of battery
O-Ring for for the PST-105S
Gasket for the PST-105
Press Door Up Pull Door Out