1-800-732-0144
10
WWW.SPORTDOG.COM
11
CHanGInG StImULatIon ranGeS
Your SDR-AH Collar Receiver comes with 3 stimulation ranges (low, medium and high).
There are 7 stimulation levels within each range, with 1 being the lowest and 7 being the
highest. The default range setting is 2 or medium.
To change the range of stimulation, follow these steps:
1. Make sure your unit is off.
2. Then turn the unit on by pressing and releasing the on/off button.
3. After the Indicator Light turns off and within 5 seconds, press and hold the on/off
button for 3 seconds.
4. The Collar Receiver will then beep once and the Indicator Light will flash orange.
This indicates
Low
stimulation range. If
Medium
or
High
are desired, continue
to hold the button until the number of beeps/orange flashes equals the desired
stimulation range shown in the chart below.
5. Release the button once the desired range is selected; the Collar Receiver will turn
off.
6. Turn the unit back on. It will then beep according to the stimulation range selected
in Step 4.
STIMULATION RANGE
DOG TEMPERAMENT
1 beep
Low
Mild
2 beeps
Medium
Moderate
3 beeps
High
Stubborn
proGram tHe remote tranSmItter
NOTE: The Transmitter is factory set to mode 1. The mode of the Remote Transmitter can
be changed to fit your type or style of training.
TO CHANGE THE MODE:
1. Referring to the table on the following page,
adjust the Intensity Dial to the mode you want
to use.
2. Turn the Remote Transmitter over and remove
the belt clip (if attached).
3. Using a pen or the tine on the buckle of your
collar strap, depress and release the mode
button. When the mode button is pressed,
the Transmitter Indicator Light will be solid in
color. When it is released, it will flash the mode selected.
For example, if mode 5 is desired, adjust the Intensity Dial to Level 5. Once the mode
button has been depressed, the Transmitter Indicator Light will be solid, and once the
mode button is released, the Transmitter Indicator Light will flash 5 times. However, if
you select mode 7 (ID Code), the light will remain solid in color once the mode button is
released.
S
T
E
P
::
0
4
400-1199.indd 10-11
8/13/10 3:50 PM
