Assembly instructions
For product codes: 131 3736, 131 3749, 131 3752,
131 3765, 131 3778, 131 3781, 131 3794, 131 5602 & 131 5615
Version 10/2021 | Page 7
Please note:
•
The wall must be of B 25 concrete quality, i.e. reinforced concrete or similar masonry. If you do not know the
specific material, please consult a specialist. The fixings must be able to withstand a tensile force of 0.50 kN.
Start by attaching the spacers
①
. Drill two holes with a diameter of 14 mm into the wall, one above the other and
75 mm apart (see figure 9). Then insert the wall plugs
④
into the drilled holes and attach the spacers using the
screws
②
and washers
③
supplied (see figure 10).
Repeat this process according to the length of your hook rail
⑧
. The spacers should be no more than 1.50 m apart
horizontally. Once all of the spacers are mounted onto the wall, hold the hook rail against them and mark the holes
on the rail. Drill the holes into the rail using a wood drill (8-mm-diameter bit). Then attach the hook rail to the
spacers using the coach bolts
⑤
, washers
⑥
and hexagon nuts
⑦
(see figure 11). Make sure the coach bolt
⑤
is mounted in the same direction as the hex-head screw
②
.
Warnings
•
The hook rail must not be subjected to a load of more than 10 kg/m.
•
Do not overload or climb on this equipment.
•
Due to continuous quality control of our products, technical changes may occur which could lead to minor
alterations to the instructions.
•
Modifications and misuse of any kind will compromise safety and render the warranty void.
Maintenance and care
•
Perform a visual inspection regularly.
•
Tighten the screw connections routinely.
•
Inspect the equipment for any damage and replace worn parts.
•
Check the condition of wooden elements for signs of wear, such as chipping.
Add-on products
Wall and floor fixings are available on request.
If you have any questions,
our experts at
Sport-Thieme
are here for you.
