Spohn & Burkhardt FS Series, Руководство по эксплуатации

Страница: 70 / 132

DRAFT
70
Spohn & Burkhardt
5. Undo the lock nut (
28
) on the cable opening (
27
) and remove the corrugated tube (
22
) from the
cable opening (
17
) on the consoles, (see Figure 16 “Cable entry”, page 66).
6. Guide the corresponding cables through the cable opening (
17
).
7. Pull the cables through the corrugated tube (
22
) and tighten the lock nut (
21
) for the cable opening
(
17
) on the spacer and the lock nut (
28
) for the cable opening (
27
) on the consoles.
8. Open the consoles see section “Variant with spacer 53035 and 53207”, page 67 point 11.
9. Connect the corresponding cables as per the related circuit diagrams ( (see chapter 12. “Reference
documents”, page 90) and requirements of the operating organization.
10. Undertake setup, (see chapter 5. “Setup”, page 70).
5. Setup
Danger!
All tasks on the device are only allowed to be undertaken by specialist personnel taking
into account the relevant safety regulations. Always pay attention to the safety instruc-
tions in chapter 1. “Safety”, page 50.
5.1. Function test
Danger!
Damaged control stands are not allowed to be operated.
1. Check the adjusting functions of the control stand FS as per chapter 6. “Operation”, page 71
• If you are not able to operate one of the adjusting functions, take the control stand out of opera-
tion and contact SPOHN & BURKHARDT ( for address see Imprint, page 2).
2. Check the functions of the controls as per the requirements of the operating organization.
• If you are not able to operate one of the functions, take the control stand out of operation and
contact SPOHN & BURKHARDT ( for address see Imprint, page 2).