Data di emissione:
Luglio, 2013
Revisione:
1
Pag. :
10/21
3. SETTING
By using the switchboard here below, it’s possible to set the machine, so that it dispenses
water and syrup in the right percentages and proportions.
1.
Keep the button PROG (central) pressed and switch on the system by using the switch on
the lid; the LED PROG (central) will start to flash waiting for further inputs.
2.
The system is ready for dispensing water and syrup together (the water quantity is fixed,
whereas the syrup quantity can be modified to obtain the requested brix value). By
pressing the button WATER (left) the 2 doses are dispensed at the same time (in other
words, one single charging cycle is dispensed); this process can be repeated till the right
mix is achieved. At the moment of the first dispensing, the quantities of water and syrup
will be the one pre-set during the manufacturing process of the machine in our premises.
3.
By pressing again the button PROG (central) the corresponding LED will stop flashing; in
this moment, the setting process of the syrup quantity starts; every flash of light on the
WATER LED (left) corresponds to 1 second of dispensing of the syrup. Once the display of
the dispensing time is finished, the WATER LED (left) turns off and the SYRUP LED (right)
starts flashing: every flash corresponds to 1 tenth of a second of syrup dispensing.
Once the display of the tenths of seconds is finished, after a stop of approx. 1 second, the
signal of the value regarding the seconds re-starts.
In order to modify the value, it’s necessary to act on the buttons WATER (left) for the
increase of the value, and/or SYRUP (right) for the decrease of the value. Every pressure of
the buttons changes the syrup dispensing value of 1 tenth of second.
To increase the syrup dispensing time of 1 second it will be necessary to push the WATER
button 10 times.
4.
Once the dispensing timing of the syrup is finished, press PROG (central) again to turn
back to point 2 and check the new regulated brix value with a refractometer.
5.
To exit the program, switch the machine off and then switch it on again.
The quantity of dispensed water depends on the pressure present in the water connection.
Set
the pressure regulator to 1.5 bar
; in this way the automatic filling system dispense approx.
450 ml of water every cycle.
MANUAL DISPENSING OF WATER AND SYRUP
The operator can also proceed with the manual refill of the water and syrup hoses by using the
electronic board as follows: when the system is off, keep pressed in the same moment both
WATER and SYRUP buttons and switch on the system; the LED PROG will steadily light up. In
this condition is possible to manually dispense water and syrup by the relative keys.
It’s necessary to perform these operations during the first installation of the
machine in order to fill up the syrup and the water hoses.
To exit this status, switch off
the system.