The pressure range for AS-103 Regulators at 3000 psi inlet pressure is 130-150 psi
( 9-10.2 bar). Add Shims (12) in either side of the spring (9) to raise the intermediate
pressure. Remove Shims to lower the pressure.
The pressure increase per shim is not linear due to the rate of the spring, so no specific
increase per shim can be given. Generally, only add a shim if the intermediate pressure (when
the cylinder pressure is 3000 psi) is below the 130-150 (9-10.2 bar) range. Adding just one
shim under these conditions will not push the intermediate pressure above the maximum 150
pressure. Do not aim for a specific pressure within the range, just add or remove shims to
get the pressure within the range.
The optimal intermediate pressure for AS-103 regulators is 140 psi (10 bar), but any setting
between 130 and 150 psi (9-10.2bar) at 3000 psi (207 bar) inlet pressure will provide good
stable performance.
Содержание Atlantis R10
