Transient Designer
5
Packaged in a standard 19 " EIA format and occupying 1U
(44,45 mm) of rack space, the T
RANSIENT
D
ESIGNER
can be installed in
a standard rack, but it is recommended that the rear of the case be
supported, especially in touring applications. The T
RANSIENT
D
ESIGNER
should not be installed near units which produce strong
magnetic fields or extreme heat. Do not install the T
RANSIENT
D
ESIGNER
directly above or below power amplifiers or digital
processors. If possible, the T
RANSIENT
D
ESIGNER
should be placed in
an 'analogue rack' where the majority (or all) of the equipment
installed is analogue. Check that the voltage details quoted on
the back panel are the same as your local mains electricity supply.
• Use a small, flat bladed screwdriver to set the voltage selector
to the voltage for the area in which the unit will be used.
• Never cover up the ventilation slots on the top side of the unit.
• If, during operation, the sound is interrupted or indicators no
longer illuminate, or if abnormal odour or smoke is detected,
or if liquids are spilled on the unit, immediately disconnect the
power cord plug and contact your dealer.
• Only clean your T
RANSIENT
D
ESIGNER
with a soft, lint-free cloth.
Use only standard cleaning agents. Never use alcohol or paint
thinner, because they may damage the finish.
Important security advices
Thanks
