P n e u m a t i c
M a g n e t i c D r i l l i n g M a c h i n e
2 1 3 3 0 0 0 1 0 / 0 0 3 0
M a s c h i n e n f a b r i k G m b H
Spitznas Maschinenfabrik GmbH, Fellerstr.4, D-42555 Velbert, Tel: +49(0)2052 605 0, Fax: +49(0)2052 605 29
, www.spitznas.de
Compiled: 27.01.10
213300010_30_en_Version_02.doc
Page 7 of 25
PROBLEM CAUSE
REMEDY
Excessive cutter
breakage
Steel swarf or dirt under
cutter
Incorrectly resharpened or
worn cutter
Cutter skipping
Slideway needs
adjustment
Cutter not attached tightly
to arbor
Insufficient use of cutting
oil or unsuitable type of oil
Remove cutter, clean thoroughly and
replace
Resharpen or replace
See above
Adjust
Retighten
Excessive cutter
wear
See above
Incorrectly resharpened
cutter
Insufficient or spasmodic
cutting pressure
Replace or resharpen
Use sufficient steady pressure to slow the
drill down. This will result in optimum
cutting speed