XU875 & XR895
11
STEP 4: RELEASE LEVER ASSEMBLY
1. Run the Seat Recline Release Cable (58) under the Seat Back Frame (5).
2. Install the Gas Cylinder (57) into the bracket of the Seat Back Frame (5) with the 1pc of 5/16
x1-3/4 Hex Head Bolt (70), 1pc of 5/16 x 19 x 1.5T Flat Washer (76), 1pc of 5/16 x 6T Nyloc
Nut (91) by using the 13/14mm Wrench (130) and 13/15mm Wrench (113). Tighten the bolt until
snug, but do not over tighten to the point of binding.
3. Remove the M6 Button Head Socket Screws holding the clamps of the left and right Release
Levers (40) by using the Allen Wrench (115). Install the 2 Release Levers (40) onto the Handle
Bar (6) just behind the hand pulse sensors. Install them at an angle that allows easy access for
use, then install and tighten the socket screws removed earlier.
4. Secure the Seat Recline Release Cable (58) and the Seat Fore/Aft Release Cable (59) on the
Handle Bar (6) by using the 4pcs of Velcro Tape. Wrap the tape around the handlebars in
places that will be under the beverage holders, when they are installed, so they are out of sight.
5. Install the Beverage Holders (38 L, 39 R) on the Handle Bar (6) with the 4pcs of 4x16m/m Self
Tapping Screws (105) by using the Phillips Head Screw Driver (114).
6. Install the Pedals (116 L, 117 R) in the Cranks by using the 13/15mm Wrench (113). Remember
that the left pedal has a reverse thread and will be screwed into the crank in the opposite
rotation from normal threads. There is an
stamped into the end of the threaded post of the
left pedal and an
in the right. Make sure to tighten the pedals as much as you possibly can.
It may be necessary to re-tighten the pedals if you feel a thumping during pedaling the bike. A
noise or feeling such as a thumping or clicking is usually caused by the pedals being too loose.
