Spirit ST900MS, Руководство пользователя

Страница: 11 / 64

9
www.spiritfitness.com
ST900MS
PRE-ASSEMBLY
TOOLS NEEDED:
‰
13/15mm Wrench, Socket,
or Adjustable Wrench
‰
17mm Wrench (2), Socket,
or Adjustable Wrench
‰
Phillips Screwdriver
‰
5mm Allen Wrench or Socket
‰
6mm Allen Wrench or Socket
To avoid possible damage to this ST900MS Multi-Station, please follow these
assembly steps in the correct order. Be sure to read your Assembly/Owner’s
Guide before using your new ST900MS Multi-Station.
NOTE: During assembly, it is recommended to ensure that all bolts are in
place and partially threaded before completely tightening any one bolt. Also,
it is recommended to apply grease to the fittings of the pillow block bearings
on the Lower Body Press and Upper Body Press Stations. This will ensure
smooth operation and prevent rust.
UNPACKING
1. Cut the straps, then pull the staples away from the bottom half and lift the top half
of the carton off of the bottom
2. The hardware is located in the holes of the associated tubes/brackets or in the
enclosed hardware kit