Group Exercise Elliptical
9
•
Slide the two swing arms (9 &10) onto the console mast axle. There is a left and right swing
arm so make sure you assemble the correct one on each side. Do not force the arms onto
the axle or use a hammer as damage to the bearings could occur. The swing arms have
been previously installed at the factory and should fit properly, although it is a snug fit.
•
Secure the swing arms in place with the M10 x 20mm stainless steel bolts (58) and cup
washers (32) and tighten. Snap the decorative caps (85) over the cup washers.
•
Connect the clear drain hoses and install the foot pedals (86 left, 87 right) with twelve M5 x
10mm screws (59)
STEP 2: SWING ARMS & PEDALS
