Spirit Esprit CT80, Руководство пользователя

Страница: 11 / 23

10
FUNCTIONS
“Speed” key
Press this key Speed
"
↑
"
or
"
↓
"
, it can adjust the running speed of the treadmill.
“Incline” key
Press this key Inclive
"
↑
"
or
"
↓
"
, it can adjust the incline of the treadmill.
“Speed shortcut key” key
Press these keys, speed walk, jog, run, it can be chosen directly which speed you want. The
highest speed is 16km/h.
“Incline shortcut key” key
Press these keys, incline 3, 6, 9, it can be chosen directly which incline you want. The highest
incline is level 12 .
“Safety” key
key Under emergent situation, pull safety key, machine stops immediately.
Getting Started
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch
located at the front of the treadmill below the motor shield. Ensure that the safety key is installed,
as the treadmill will not power on without it. When the power is turned on, all the lights on the
display will light for a short time.
Self-Checking
When using for the first time, it is necessary to make the machine carry on
self-check:
·
Remove the safety key, press MODE and hold, then insert the safety key again, the machine
enters into self-checking state. During this state, pressing START can terminate the self-
checking.
Quick-Start Operation
1. Press and release the START to wake display up (if not already on). Note: Installing the safety
key will also wake up the console.
2. Press and release the START to begin belt movement, at 1.0 Km/hr, then adjust to the desired
speed using the
"
↑
"
or
"
↓
"
. You may also use the rapid speed keys (walk, jog, run, ) to adjust
the speed. The speed range is from 1.0km/h to 16.0km/h.
3. To slow the treadmill down, press and hold the ‘
↓
’ key to desired speed. You may also press the
rapid speed adjust keys: walk, jog, run.
4. In a state of running, single press STOP, the walking belt will gradually slow down if the speed
is above 1.5km/h, if under 1.5km/h, then it will stop immediately.
5. In the state of running, single press CLEAR will reset all number except the speed. Then enter
into manual mode.
6. To stop the tread-belt press and release the STOP.