Spirit Commercial CE900, Руководство пользователя

Страница: 27 / 32

25
www.spiritfitness.com
GENERAL MAINTENANCE
Wipe down all areas in the sweat path with a damp cloth after each workout. If a squeak, thump, clicking or
rough feeling develops the main cause is most likely one of two reasons:
1. The hardware was not sufficiently tightened during assembly. All bolts that were installed during assembly need
to be tightened as much as possible. It may be necessary to use a larger wrench than the one provided if you
cannot tighten the bolts sufficiently. It is important to note that 90% of calls to the service department for noise issues
can be traced to loose hardware.
2. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise from build-up on the
aluminum tracks can cause a thumping sound that you would think is coming from inside the main body of the
machine because noise travels, and is amplified, in the tubing of the frame. Clean the tracks and wheels with a lint
free cloth and rubbing alcohol. Stubborn build-up can be removed with your thumbnail or a non-metallic scraper, like
the back edge of a plastic knife.
If squeaks or other noises persist, check that the unit is properly leveled. There are 6 leveling pads on the bottom of the
machine, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
MAINTENANCE MODE MENU
The console has built-in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a button is pressed for
example. To enter the Maintenance Mode, pedal the elliptical and press and hold down the Start, Stop and
Enter buttons. Keep holding the buttons down for about 5 seconds and the Message Center will display
Maintenance Mode. Press the Enter button to access the menu below:
1. Button Test (Will allow you to test all the buttons to make sure they are functioning)
2. Display Test (Tests all the display functions)