Spinning 800.847.SPIN, Руководство пользователя

Страница: 10 / 28

©2016 Mad Dogg Athletics, Inc. All rights reserved. Spin®, Spinner®, Spinning®, Spin Fitness®, SPINPower® and
the Spinning logo ® are registered trademarks that are owned by Mad Dogg Athletics, Inc.
10
cadence sensor
foam block
double-sided
adhesive
3. Once the magnet is in the slot or positioned near the pedal
spindle, peel the adhesive cover off of the magnet-holding shim
and place it around the magnet on the inner surface of the right
crank arm.
NOTE: The cadence sensor must be within 10 cm (.4 inches) of the magnet
for pairing.
Sensor Installation, Inside the Chain Guard:
NOTE: This process is intended for all of the latest models of Spinner®
indoor cycling bikes manufactured by Precor®.
1. Lock the flywheel and pedals
by turning the resistance knob
clockwise.
2. Remove the inner chain guard
panel by removing the four
screws with a 5mm hex key /
Allen wrench (Fig. 4).
3. Place the cadence sensor
inside the foam holder (Fig. 5).
4. Affix the strip of double stick
adhesive to the underside of
the cadence sensor and foam
holder to cover the battery
access cap.
cadence sensor
foam holder
double-
sided
adhesive
F ig. 5
Fig. 4
screw locations