7
INSTALLATION
Regulations and Standards
This appliance shall be installed in accordance with the local and National/European
standards in force. Failure to install the appliance correctly could invalidate any warranty or
liability claims and lead to prosecution. Read the instructions before installation or use.
Position
The appliance must be installed in an enclosure consisting of sides, rear, floor and roof,
see Fig. 1 – Installation Details. There should be no gaps or vents between or in the
enclosure panels, which allow access to the cooker. Kickboards must not be removable
without the aid of a tool. All combustible materials such as curtains and shelves must be
kept well clear of the appliance
In your own interest of safety, the appliances should be installed by a member of the
N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations.
Connection
Access to the mains terminal is gained by removing the terminal cover box – see Fig. 2.
The appliance must be connected using a double insulated cord, type 227 IEC 53, HO5V
V-F, which is suitable for use up to 13 amps. This should be connected to a double pole
switched mains supply, with 3mm minimum contact separation at all poles.
The supply cord MUST be retained using the attached cable clamp any excess cord
MUST be routed away from the appliance and not come into contact with the appliance or
hang loose into a lower compartment.
Fixing
There are 8 fixing screw positions, 2 in each side trim of the Grill opening and 2 in each
side trim of the Oven opening
Make sure the appliance is fully home in the cabinet/aperture. Open the Oven door and fix
the screws in position. Finally open the Grill door and fix the screws in position.
MAINTENANCE & SERVICING
This appliance needs little maintenance other than cleaning. All parts should be cleaned
using warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders.
WARNING
•
THIS APPLIANCE MUST BE EARTHED
•
WHEN INSTALLING AT EYE LEVEL, ANY CUPBOARDS BENEATH OR
ABOVE THE APPLIANCE MUST BE SEALED TO PREVENT ACCESS.
WARNING
•
ENSURE THAT ALL ELEMENTS ARE SWITCHED OFF AND COOL
BEFORE CLEANING.
•
THIS APPLIANCE MUST NOT BE MODIFIED OR ADJUSTED UNLESS
CARRIED OUT BY THE MANUFACTURER OR HIS REPRESENTITIVE. NO
PARTS OTHER THAN THOSE SUPPLIED BY THE MANUFACTURER
SHOULD BE USED ON THIS APPLIANCE.
Содержание COUNTRY LEISURE PRIMA 600EL
Страница 2: ...2 ...
