1.
Stand at least 4’
from the wall.
2.
Only drive
on empty walls,
(no hanging
pictures or
other obstacles)
and avoid driving
on walls that have
anything underneath
them. The Zero Gravity Micro™ could
get damaged if it were to fall.
Note:
Use only on smooth, clean
surfaces and clean the tires with a
damp rag before each use. Do not run
on damp surfaces.
3.
DO NOT drive over wall
sockets, light switches or
other obstructions.
4.
Do not drive to or off the
edge of the wall.
4’
IMPORTANT:
The Zero Gravity
Micro™ Wall Racer has
working headlights.
When the headlights begin to blink,
the rechargeable battery is running
low on power and should be removed
from the wall immediately. Otherwise
the vehicle will fall off the wall.
2.
To drive on the walls
you must put the vehicle
in the
WALL
mode. To
do that, move the power
switch at the back of the
vehicle all the way to the
LEFT.
1.
Turn the
controller/charger
“
ON”
.
IMPORTANT:
Before turning controller
ON, make sure that both
joysticks are in the neutral
(middle) position.
4.
The fabric air skirts
can be adjusted outward
at a 45° angle to
ensure a proper vehicle
air suction to the wall.
WHILE DRIVING YOUR ZERO GRAVITY MICRO™ WALL RACER, MAKE SURE TO OBEY THESE RULES
DRIVING ON WALLS
neutral positions
Fabric
air skirt
3.
Place the
vehicle on the wall
as shown.
5.
Avoid driving on the ceiling when other people are around.
6.
Do not stand underneath when driving on the ceiling.
7.
Never get alcohol on the fabric air skirt.
