78-2600-R - Instructions MAVERICK TRAIL-SPORT-COMMANDER Vent Rear Windshield - rev00
www.spikepowersports.com / 888-769-2295
2
IMPORTANT NOTICES
Torque specifications must be followed when tightening bolts.
Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
warranty.
b)
Vent assembly (Item B) installation:
Partially remove the protective film on
both sides of the windshield around the vent cutouts and follow instructions
below.
a.
From the front side (cab side) of the windshield, slide the vent flap
assembly (Item B) in the vent cut out as shown in image b1. Ensure the
lower tab nests into the front of the windshield as shown in image b2 & b3.
b.
Install the remaining vent components (Item B) using supplied hardware
as shown below in image b4 & b5.
Caution: over tightening any hardware could cause irreversible
damage to the windshield.
DO NOT USE POWER TOOLS FOR THE INSTALLATION
OF THE 7 MOUNTING SCREWS.
Vent flap
assembly
b1
b2
Windshield
vent cut out
Back
side
Vent cover
Rubber vent
seal
Vent mounting screws (7x)
(
2.0 ± 0.2 N•m / 18 ± 2 lbf•in
)
Back
side
Front side
(cab side)
b4
SIDE VIEW
SIDE
VIEW
As shown on the front-view image, the
lever
is installed
by default on the right side of the vent.
Lever can be installed/relocated on left or right side of
the vent. End user can decide.
Tightening/Loosening of the
screw
in the lever
determines the force required for the
baffle
adjustment.
BACK VIEW
Front side
(cab side)
FRONT VIEW
(CAB SIDE)
b5
BACK VIEW
Lower tab
b3
SIDE
VIEW
Back
side
Front side
(cab side)
REAR VIEW
