SK1265-AT6
Diesel engine truck
Truck
SPIERINGS MOBILE CRANES USER MANUAL V 2.9
10-17
M
ei
2
0
1
8
Cha
n
g
e
s
a
n
d
t
y
p
o
g
ra
p
h
ic
a
l e
rr
o
rs
r
e
s
e
rv
e
d
.
©
2
0
1
8
S
p
ie
ri
n
g
s
M
o
b
ile
Cr
a
n
e
s
–
A
ll r
ig
h
ts
r
e
s
e
rv
e
d
.
Replacing the fuel pre-filter / water separator (
) must be carried out as mentioned below.
1. Put a tray under the filter;
2. Let the fuel out of the filter element by opening
drainage plug C
) at the bottom
of the water separator;
3. Remove the
filter element A
) together with the
bottom cover B
by turning it counterclockwise;
4. Remove the filter element from the bottom cover;
5. Clean the bottom cover;
6. Replace the O-ring and grease the new O-ring lightly;
7. Mount a new filter element on the bottom cover and fill with clean diesel;
8. Replace the sealing ring and lightly grease the new ring;
9. Mount the bottom cover together with the filter element on the filter casing:
-
Tighten the filter element by hand;
10. Vent the fuel system (see
§ 10.4.5. Venting fuel system diesel engine truck
11. Start the engine and let it run for a few minutes;
12. Tighten the filter element by hand;
13. Check the fuel system for leakage.
10.4.4.
Fuel filter diesel engine truck
The fuel filter is situated on the left side of the diesel engine (
Picture 10-15
Picture 10-16