SPIDO 002650, Руководство по эксплуатации

Страница: 15 / 26

4
The pump must not be used in such locations unless it is set up firmly and flood-proof, a minimum distance of two
metres away from the border of the water body and secured against falling into the water by a solid holding
device.
6. Electrical con Q ection
The unit is equipped with a mains connection cable and a mains plug. It must only be replaced by qualified staff to
avoid any danger. Please do not use the mains connection cable to carry the pump, and do not use this cable to
pull off the plug from the socket, either. Protect the mains connection cable and mains plug from heat, oil or sharp
edges.
The values stated in the technical details have to correspond to the mains voltage. The person
responsible for the installation has to make sure that the electrical connection is earthed in
compliance with the applicable standards.
The electrical connection has to be equipped with a highly sensitive residual current circuit-
breaker (FI switch): ∆ = 30 mA (DIN VDE 0100 -739).
If extension cables are used, their cross-section must not be smaller than that of rubber-
sheathed cables of the H07RN-F (3 x 1,0 mm²) short code. The mains socket and the plug-
and-socket elements have to be in splashwater-proof design.
7. Putting into operation
11
The pump must only be operated in the performance range indicated on the type plate.
Any dry-running - i.e. the operation of the pump without and discharging any liquid - is to be
avoided since this will lead to the pump running hot. This may entail considerable damage to
the device. In addition, overheating bears the risk of injury by burning. If the pump has run hot,
please unplug the mains plug and allow the system to cool down.
Please do not expose the pump to moisture (e.g. when operating sprinklers). Do not expose
the unit to rain, either. Make sure that no dripping connections are located above the pump.
The pump should not be used in wet or moist environments. Make sure that the pump and the
electrical plug connections are arranged in a flood-proof place.
The pump must not be operated over any extended period of time with the withdrawal point
closed. The fuel nozzle is to be opened immediately following power-up of the pump. As soon
as tapping is finished, the pump should be switched off.
While the pump is running, nobody must be in contact with the liquid being pumped. Do not
operate the pump while you are in contact with water. The pump must not be moved during
operation and has to be under an interrupted supervision.
As long as the device is connected to the electrical mains, one must never reach with one’s
hands into the opening of the pump.
Please inspect the pump visually prior to each use. This applies in particular to the mains connection line and the
mains plug. Make sure that all screws are firmly tightened, and verify the perfect condition of all connections. A
damaged pump must not be used. In any case of damage, the pump has to be inspected by qualified service
staff.
Insert the mains plug into a 230V AC socket. Start the pump by operating the on/off switch. Immediately
afterwards, open the fuel nozzle. As soon as tapping is completed, please switch off the pump immediately by
pressing the on/off switch again.