Spidem 740617323, Руководство по эксплуатации

Страница: 31 / 120

ENGLISH
• 31 •
button (Fig.22)
• Make sure that the two steel filters are free
from any coffee residues. The top filter can
be removed by unscrewing the plastic pin
anticlockwise using the specific supplied key
(Fig.23.).
• Wash the coffee dispenser only with hot water:
do not use detergents. Then accurately wash
and dry all its components.
• Refit the filter and carefully screw the plastic
pin back on using the specific key.
• Clean the compartment inside the appliance.
• Holding it by its handle, insert the coffee
dispenser into its housing until it snaps into
place.
• Insert the coffee grounds drawer, the drip tray
plate and the drip tray.
• Close the cover (15).
11 DESCALING
Scaling occurs naturally when the appliance is
used. Approximately every 3-4 months you
should descale it; it is ready for descaling when
you notice a reduction in the water flow or when
the LED of the button (26) flashes.
If you wish to carry this out at home,
you can use a descaling product for
coffee makers that is non toxic and/or not
harmful and commonly available on the
market.
Caution! Never use vinegar.
To descale the appliance proceed as follows:
• Mix the descaler with water as specified on
the package and fill the water tank.
• Switch ON the appliance with the ON/OFF
switch (7).
• Press the button (26) for at least 5 seconds to
select the descaling operating mode; the LED
emits a fixed light.
• Direct the steam nozzle (14) toward the drip
tray.
• Position a vessel of adequate capacity under
the steam nozzle and turn the hot water knob
anticlockwise (16). The appliance starts an
automatic descaling cycle with pauses preset
by the manufacturer and managed
automatically by the appliance.
• At the end of the cycle, the flow of the
descaling solution is shut off and the 5 buttons
start flashing simultaneously.
• Turn the knob of the hot water nozzle (16)
clockwise to OFF. In this case, also the warning
light (27) flashes.
• Rinse the water tank and fill it with fresh
drinking water.
• Position a vessel of adequate capacity under
the steam nozzle and empty 2/3 of the
contents of the water tank by turning the steam
knob (16) anticlockwise; to shut off the flow,
turn the knob (16) clockwise.
• Let the appliance heat up and empty the
remaining contents of the water tank by turning
the steam knob (16) anticlockwise; to stop the
flow, turn it clockwise.
If you use a different product from
the recommended one, we
recommend you follow the instructions of
the descaler manufacturer as specified on
the package.
If the descaling cycle is interrupted
by switching the machine OFF, this is
restarted when the machine is switched back
ON.
12 FUNCTION PROGRAMMING
The appliance allows you to programme some
parameters depending on your needs.
To programme the functions, you must enter
programming mode as follows:
• Ensure that the ON/OFF switch (7) of the
appliance is switched to “O” and that the hot
water knob (16) is OFF.
• Press the buttons (23) and (25) and, at the
same time, switch ON the appliance using
the ON/OFF switch (7).
You are now in the programming mode.
To quit the programming mode and
implement your changes, switch the machine
OFF and, then, back ON again using the
main switch (7).