U s e r I n s t r u c t i o n s - E n g l i s h
3
2.0 General Requirements,
Warnings and Limitations
1.0 Purpose
The Miller Adjustable Rope Lanyard is a fall protection accessory product/positioning device designed to
allow linemen to bypass obstructions safely in pole climbing applications. The Adjustable Rope Lanyard
must be used in conjunction with the Miller StopFall Fall Restraint System or with another Miller approved
work positioning and fall arrest system for climbing poles.
Model No.
Materials
Length
ARL-100-Z7/8FT
10.5 mm polyamide kernmantle rope; steel cam adjuster;
steel snap hook; steel carabiner
8 ft. (2.4m)
All persons using this equipment must read, understand and follow all in-
structions. Failure to do so may result in serious injury or death. Do not use
this equipment unless you are properly trained.
WARNING
All warnings and instructions shall be provided to
authorized persons/users.
All authorized persons/users must reference
the regulations governing occupational safety,
as well as applicable ANSI or CSA standards.
Proper precautions should always be taken to
remove any obstructions, debris, material, or
other recognized hazards from the work area that
could cause injuries or interfere with the operation
of the system.
All equipment must be inspected before each use
according to the manufacturer’s instructions.
$OOHTXLSPHQWVKRXOGEHLQVSHFWHGE\DTXDOL¿HG
person on a regular basis.
To minimize the potential for accidental
disengagement, a competent person must ensure
system compatibility.
All Miller fall protection products are designed
for use with Miller approved components.
Substitution or replacement with non-approved
component combinations or subsystems or both
may affect or interfere with the safe function of
each other and endanger the compatibility within
the system. This incompatibility may affect the
reliability and safety of the total system.
Equipment must not be altered in any way.
Repairs must be performed only by the
manufacturer, or persons or entities authorized in
writing by the manufacturer.
Any product exhibiting deformities, unusual wear,
or deterioration must be immediately discarded.
Any equipment subject to a fall must be removed
from service.
The authorized person/user shall have a rescue
plan and the means at hand to implement it when
using this equipment.
Never use fall protection equipment for purposes
other than those for which it was designed.
Equipment must not be exposed to environmental
hazards and chemicals which may produce a
harmful effect.
Use in a corrosive or caustic environment dictates
a more frequent inspection and servicing program
to ensure the integrity of the product is maintained.
Do not allow equipment to come in contact
with anything that will damage it including, but
not limited to, sharp, abrasive, rough or high-
temperature surfaces, welding, heat sources,
electrical hazards, or moving machinery.
Do not expose the equipment to any hazard
which it is not designed to withstand. Consult the
manufacturer in cases of doubt.
Always check for obstructions below the work
area to make sure potential fall path is clear.
Allow adequate fall clearance below the work
surface.
Never remove product labels, which include
important warnings and information for the
authorized person/user.
Содержание Miller ARL-100-Z7/8FT
Страница 1: ...I306 Rev A MFP9720187 6 April 2011 ...