Spellman SPX Series, Руководство пользователя

Страница: 5 / 51

SPX X-ray
Industrial Imaging System
Page 3 of 44 SPX Series System Manual
118173-001 Rev. D
Chapter 1
:
Introduction and General Information
Introduction
This manual describes the SPX series portable
Industrial X-ray Unit and explains the procedures
To properly set up, inspect operate and maintain
Intended Use
The SPX series is designed to meet the needs of the
commercial NDT user. The system is intended for, but
not limited to, the inspection of
materials for:

Defects

Inclusions

Cracks

Corrosion

Porosity
SYSTEM OVERVIEW
The SPX series can generate x-ray potential up to 160,
200 and 300 kilovolts (kV) and tube current up to 10
milliampers (mA). The maximum allowable dissipation
is 800 watts for the SPX-160 and 900W for the SPX-
200 and SPX-300. Maximum tube current is limited
automatically by the Control unit to 10mA, or to a value
that does not cause dissipation greater than rated
power (watts) at a set kV level.
The system offers 100% duty cycle and consists of the
following assemblies:

The Control Unit

The Tube Head

The Cooling Unit, liquid cooled units only)

The Electric Cooling Fan (air cooled units only)
These assemblies are described in detail next.
The SPX X-ray System
Figure 1-1