F10F Series Booster User’s Manual
-
4
-
4. Introduction
There are millions of very small areas (10~100 square meters) where people work or live in
and suffer from very poor or no mobile signals. People are seeking a cheap and immediate
solution that would allow them has clear phone calls or higher speed broadband. However
most of the current booster solutions usually have larger coverage size, and not cost
effective.
F10F series is specifically designed as a "CHEAP" solution to meet this request.
F10F single system series is supports any one system of GSM900, DCS and WCDMA;
and F10F-DB series is supports any two system of GSM900, DCS, WCDMA.
F10F series is quite elegant metal design and can be held in palm. The single system size
is only 95*129*30mm; and the dual system is only 156*129*30.The power consumption is
only 8.5W.
Composition of Application System:
1)
Donor antenna:
Recommend using wide band panel antenna (7~14dBi gain) or
Yagi antenna, better to use antenna with good direction, high gain, and
decoration shall be considered if it is in urban areas.
2)
Role:
It picks up signals from the tower, and sends to the booster through cables,
at the same time, it transmits the amplified mobile signals from the booster to the
tower.
3)
Server antenna:
Recommend using whip antenna or indoor panel. Whip
antenna is suitable for wide open areas where the signals can be radiated from
the center to the surroundings, while indoor panel is suitable for those narrow
and long areas, like tunnels, corridors, elevators, etc.
4)
Cables:
3D-FB or 5D-FB coaxial cables.
5)
Power supply:
Booster power adapter, a desktop standard. Usually directly
connected to a power outlet. But preferably equipped with an air switch,
groundings, sometimes a surge arrestor shall be connected.
6)
Standard F10F is supplied as a kit, including a donor antenna, a 10 meter long
cable and a whip antenna.