Radio Installation:
1. Mix up a small amount of 5-minute epoxy and
paint the bottom of each servo pocket. This is to done
so that the servo tape has something to stick to.
2. Connect all of your radio components and test
your servos for proper movement. Looking from the
back of the wing, when giving up elevator, you will
want the both servo arms to move forward. When
giving down elevator, you will both servo arms to
move backwards. When giving right aileron, the right
servo arm should move forward and the left servo arm
should move backwards. When giving left aileron,
the left servo arm should move forward and the right
servo arm should move backwards.
3. Make a shallow slice in the foam between the radio
bays. You will later bury the servo and speed control
wires in these slices.
4. Place some servo tape on the bottom of the servos
and place the servos in their precut pockets. Also,
make a small hole in the speed control pocket for the
battery connector to
fi
t through.
5. Install the rest of your radio gear. Make a shal-
low slit in the wing going the one wing tip and press
the receiver antenna in the slit with your thumb nail.
Leave the excess antenna dangle from the tip at this
point.
6. Find the two radio bay covers and glue them over
the speed control and receiver bays. I use a small
amount of Medium CA and CA Kicker.
