7. Using a straight edge, mark the location of the 1/2A
control horns on the elevons.
8. Mount the control horns making sure that the push
rod holes are directly above the hinge line. You can
use an X-acto to make a small starter hole for the
control horns to press into. Use medium CA to glue in
control horns.
9. Install the Micro EZ connectors on the servo horn.
(I use the second hole from the bottom of the servo
horn).
10. Make a Z-Bend in one end of each push rod.
11. Attach the Z-Bend end of the push rod to the top
hole in the elevon control horns. Slide the other end
though the Micro EZ Connects and tighten the screw
when the elevons are level. Cut off excess wire.
13. Attach the motor using the tie wraps included in
your kit.
12. Cut the covering off of the cooling holes in the
speed control cover. You can cut them off of the re-
ceiver cover as well, but it isn’t necessary.
