1
MAINTENANCE /
REP
AIR
TROUBLESHOOTING
OPERA
TION
ASSEMBL
Y /
INST
ALLA
TION
SAFETY
/
SPECIFICA
TIONS
GETTING ST
ARTED
BEFORE YOU BEGIN
Introduction
Air compressor units are intended to provide compressed air to power pneumatic tools, operate spray guns and
supply air for pneumatic valves and actuators. The pumps supplied with these units have oil lubricated bearings.
A small amount of oil carryover is present in the compressed air stream. Applications requiring air free of oil
vapor should have the appropriate filters installed. Any other use of these units will void the warranty and the
manufacturer will not be responsible for problems or damages resulting from such misuse.
QUICK REFERENCE
Required Oil (2 Options)
Single viscosity SAE30 ISO100 nondetergent compressor oil. Part number 4ZF21 or
1WG50.
10W30 synthetic oil such as Mobile 1 or 1WG49.
Oil Capacity
Approximately 8.5 oz. (Unit not shipped with oil)
UNPACKING
Do not lift or move unit without appropriately rated equipment. Be sure
the unit is securely attached to lifting device used. Do not lift unit by holding onto
tubes or coolers. Do not use unit to lift other attached equipment.
After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for
loose, missing or damaged parts. Check to be sure all supplied accessories are enclosed with the unit. In case of
questions, damaged or missing parts, please call 1-855-504-5678
for customer assistance.
Do not operate unit if damaged during shipping, handling or use. Damage
may result in bursting and cause injury or property damage.
