Speed Passion Carrera 2, Инструкция по эксплуатации

Страница: 9 / 16

NOR REV NOR
RADIO
BIND
REV
POWER
LED
G:FULL
F:LOW
ST.TRIM TH.TRIM ST.D/R
2
2
0
3 1
1 3
0
3 1
1 3
2
2
3
1
0 2
4
5
6
Our products are bound from the factory, so you do not need to bind them
yourself. To bind the receiver with another transmitter, please follow the
following steps:
A. Install the battery to 2.4G transmitter
B. Insert the bind plug to the channel BIND /CH3 port of the receiver.
C. Connect the receiver battery to VCC port of the receiver. The two LED will
be flashing and this means the receiver is ready to bind.
D. Press and hold the bind button on the transmitter, and then switch on the
power.
E. Observe the LED on the receiver, if the LED is not flashing, the bind was
successful.(May take about 5s )
F. Release the bind button on the transmitter, and remove the bind plug from
the receiver.
G. Install a servo and test.
H. If the test fails, please repeat the process above.
I. If the tests succeeds, the bind is complete. (The above ways of match is
only suitable on this products)
Bind Plug
LED