How to use the power station to start a vehicle:
1. The ON/OFF switch can be set to ‘0FF’ position for the
starting aid function.
2. Connect the POSITIVE pole (+) of the power station to
the POSITIVE pole (+) of the vehicle battery.
3. Connect the NEGATIVE pole (-) of the power station to
the NEGATIVE pole (-) of the vehicle battery.
4. Leave the power station connected to the vehicle battery
for around 20 minutes.
Important! Never attempt to start the vehicle with the
power station connected.
5. After approximately 20 minutes, disconnect the jumper
cable from the NEGATIVE pole (-) of the vehicle battery.
6. Then disconnect the jumper cable from the POSITIVE
pole (+) of the vehicle battery.
7. This partial charge should be sufficient to start the vehicle.
8. The power station will need to be recharged after giving
this starting aid.
7. Controls
1. Plug-in fuse (10A)
2. Miniature fuse (1A)
3. ON/OFF switch
4. Battery condition indicator
5. Output sockets 3V / 6V /9V
6. Output sockets 12V via cigarette lighter socket
7. Charging socket
8. Negative pole for starting aid
9. Positive pole for starting aid
8. Battery condition indicator
LED 1 and LED 2 work in connection with the charging of
the storage battery. LED 2 lights up when the power supply
unit is connected to the power station. LED 1 lights up in
addition when the storage battery is fully charged.
LED 3 and LED 4 provide information about the condition of
the storage battery. LED 4 lights up when the power
station´s storage battery is fully charged. LED 3 lights up
when the power station´s storage battery is empty. The
power station should be recharged when LED 3 lights up.
9. Maintenance and cleaning
Be sure to switch off the power station and disconnect all
cables from the unit whenever you perform any cleaning
or maintenance work.
As far as possible, use only a soft dry cloth without any
aggressive detergents to clean the surface. If absolutely
necessary, use a slightly dampened rag to remove dirt.
10. Ordering spare parts
1. Please provide the following information if you need any
spare parts:
2. Type of unit
3. Article number
4. Identification number
5. Number of the required spare part
5
GB
Anleitung MPS 120 17.04.2003 9:26 Uhr Seite 5
