OPERATING INSTRUCTIONS
WARNING: Read and thoroughly understand all instructions and safety information before operating
this log splitter. Failure to do so may cause serious injury or death. Do not allow anyone to operate
this log splitter who has not read this manual. As with all power equipment, a log splitter can be
dangerous if assembled or used improperly. Do not operate this log splitter if you have doubts or
questions concerning safe operation. Call our customer service department at 1-800-525-8322 to
address these concerns.
Si no entiende ingles, se prefiere que busque alguien que interprete las instrucciones para usted.
Page 6
WARNING: See safety information related to operation of the log splitter on pages 1 through 5 of this manual.
Make sure that you have the recommended personal protective equipment described on page 1.
1) Set up the log splitter in a clear, level area.
2) Place a log on the beam against the foot plate. Make sure the log is securely on the foot plate and up against the beam.
3) Depress the valve handle so that the cylinder will drive the wedge into the log. Extend the cylinder until the log splits or to the
end of its stroke. If the log has not completely split after the cylinder has reached the end of its extension, retract the cylinder.
IMPORTANT: Leaving the valve in the “actuate” position at the end of the stroke may damage the pump. Always use extra care
when splitting logs with unsquare ends.
IMPORTANT:
TO EXTEND THE LIFE OF THE HYDRAULIC CYLINDER, AVOID “BOTTOMING OUT” WEDGE PLATE TO THE FOOT
PIECE. TO CONFORM WITH INDUSTRY SAFETY RECOMMENDATIONS, THE WEDGE STOPS 2 INCHES FROM
THE END OF THE STROKE.
WARNING: TILT SLOWLY! DO NOT MOVE FROM VERTICAL TO HORIZONTAL POSITION UNLESS
FRAME LEGS ARE SECURELY IN PLACE. TRACTOR LIFT ARMS COULD FALL
RESULTING IN SERIOUS INJURY.
1) With normal use the log splitter will not require any regular maintenance other than checking for loose bolts and the inspection
of hoses and fittings.
2) If the wedge becomes dull or nicked, it can be removed and sharpened. Remove the 1/2 in. diameter bolt that connects the
wedge to the cylinder. The hose from the valve may need to be removed. While the log splitter is in the horizontal position,
loosen the hose clamp and disconnect the hose from the valve. Carefully lift the cylinder to allow the wedge to slide forward.
The wedge can now be lifted off and sharpened.
3) See also Repair and Maintenance Safety on page 4 of this manual.
4) All replacement parts must meet manufacturer’s specifications.
MAINTENANCE
Log splitter quickly converts to the horizontal posi-
tion. Just lower the beam on hinge and lock in place
with lynch pin (22).
