EVER
PREPARATION OF THE LOG
Both ends of the log should be cut as square as possible to help prevent the log from riding out of the splitter during
operation. Do not split logs greater than 26 in. in length.
WORK AREA
NEVER
operate the log splitter on slippery, wet, muddy or icy ground.
ONLY
operate your log splitter on level ground. Operating on a slope could cause the log splitter to roll over or logs to fall
off.
NEVER
operate your log splitter in an enclosed area. Exhaust fumes contain carbon monoxide which can be deadly when
inhaled.
NEVER
attempt to move your log splitter over hilly or uneven terrain without a tow vehicle or adequate help.
ALWAYS
block the wheels to prevent movement of the log splitter while in operation.
ONLY
operate your log splitter in daylight or under good artificial light.
ALWAYS
keep the work area clean. Remove split wood around your log splitter immediately so that you don’t stumble
over it.
OPERATION OF THE LOG SPLITTER
ONLY
operate the log splitter from the operator zone.
KNOW
how to stop the log splitter and disengage the controls before operating it.
NEVER
place hands or feet between the log and splitting wedge during forward or reverse stroke. Serious injury or death
could result.
NEVER
straddle or step over the log splitter during operation.
NEVER
reach or bend over the log splitter to pick up a log.
NEVER
try to split two logs on top of each other.
NEVER
try to cross split a second log.
NEVER
allow one person to operate the valve while another is positioning the log.
NEVER
attempt to load your log splitter when the ram or wedge is in motion.
ALWAYS
use your hand to operate the control lever on the valve. NEVER use your foot, a rope or any extension device.
Shut off the engine even if you are leaving the log splitter for a short period of time.
Page 3
Operator
Zone
