Copyright 2020. Speech Recognition Solutions, LLC.
Mac Set-up:
Preliminary Setting Tweak:
Although the TableMike is essentially a “plug
-and-
play” device,
the
following brief adjustment is recommended when preparing to use a TableMike with your
Mac:
1.
Go to the Utilities folder in your Applications folder, and launch 'Audio MIDI Setup'.
Select 'USB TableMike' from the list of devices.
2.
Click on the 'Input' tab, then choose '44000.0 Hz' and '1ch-16bit' from the Format
menu.
3.
Quit the Setup
Dragon for Mac Set-up
Because of the unique "auto-gain" technology on the 2nd Generation TableMikes, it is
recommended that you follow the procedure listed here when doing the initial microphone set-
up when using it with Dragon Dictate®. This is necessary in order to give the TableMike time to
achieve maximum sensitivity before initiating the volume setting procedure.
•
Choose Tools > Microphone Setup to calibrate the TableMike™
•
Click on the red icon to enable the microphone
•
Wait 30 seconds in silence until the gain setting reaches the maximum level of
99
At this point, start reading the text to have Dragon Dictate® adjust the TableMike's volume
properly.
After following the above procedures you can expect excellent results with any of the
SpeechWare microphones.
Operating Instructions
Depending upon which version of the TableMike you have purchased, there are several
potential controls to be aware of. The control buttons used in all three TableMikes is shown
