Spectrum Swim-Lift Gallatin WP400, Руководство пользователя

Страница: 5 / 14

Anchor Installation
If you purchased and installed a Swim-Lift® Pre-Set Anchor previously or if your Retro-
Fit Anchors are already installed, please proceed to the Lift Assembly Section on page 7.
Anchor Location
It is recommended that the Gallatin be installed in or near the shallow end of the pool
with sufficient deck space and operational area in the pool as shown in figure 2. For
reasons of safety and ADA guidelines, the lift must be installed in a location that is clear
from the obstacles and other hazards.
NOTE: Do not locate the lift in a corner or directly adjacent to pool ladders/handrails or
grab rails that could interfere with the rotation of the lift. Do not place the lift where it
may be cumbersome or hazardous to any pool users.
Because the lift can be stopped at any position during lowering, there is no minimum
pool depth requirements for the Gallatin. However, to comply with ADA guidelines, the
Gallatin must be installed at a pool depth no greater than 48-inches and the seat should
submerge to a minimum depth of 18” below the surface of the water. For the standard
base anchors may be installed between 20” and 30” from the pool/spa edge with the
recommended anchor setback at 28”. For the Short base anchors may be installed
between 18” and 24” back from the pool/spa edge with recommended anchor setback at
22”. Make sure that the center of both anchors are the same distance from the edge of the
pool. Refer to figure 3 to optimize the position of the leveler foot. There must be at least
6” from the center of each anchor to the nearest joint, crack, curb or similar concrete
structure to ensure the strength of the concrete.
In addition, all installations should be in accordance with the ADA guidelines
(ADA guidelines are available at the website www.access-board.gov ).
NOTE: Optional base stand configurations are available if this setback range or
anchor location will not work with your pool.