Windrowe Series Assembly Instructions
3
CASTERS/GLIDES
2
1
4
6
5
7
ARMS
8
HEAD
REST
9
PADDLE
10
1) Remove base, back, pneumatic cylinder,
casters/glides, and seat from box.
2) Insert casters/glides
2
on base
1
. Using
pressure, push the casters/glides into the
base making sure they are all the way in.
3) Place base
1
with legs on hard level surface.
4) Insert cylinder
3
into center hole of base and
lightly push down.
5) (Optional) Arm rests
8
are factory installed
for shipping. Use enclosed allen wrench to
adjust width of arms: loosen screw, adjust
arms, tighten screw.
6) Turn seat upside down and place on the
edge of a table to slide the back bar into
position.
7) Attach back bar to seat
4
using 3 bolts
and 3 washers. Firmly tighten with enclosed
allen wrench.
8) (Optional) Attach headrest
9
to top of seat
back
7
and using enclosed allen wrench,
insert and tighten 2 screws to back.
9) Turn assembled seat over and align the
center hole on the bottom of the seat with
the top of the pneumatic cylinder and lightly
push down. With the weight of your body,
carefully sit on the seat. This will press the
base, pneumatic cylinder, and seat together.
