Logo/Company Name
4”w x .75”h
Assembly Instructions
1) Remove base, back/back bar, pneumatic cylinder, seat,
foot ring (if included) and casters/glides from box.
2) Place base (1) upside down and insert casters/glides (5)
(see figure 1).
3) Slide
optional
foot ring (4) over pneumatic cylinder from
bottom (2) about halfway up the cylinder and tighten knob (7).
4) Flip the base so casters/glides are on the floor and insert
pneumatic cylinder (2) as shown in (figure 3) into center
hole of base with colored button up. Lightly push down.
Adjust foot ring to desired height.
5) Align the center hole of the underside of the seat assembly
(3) with the top of the pneumatic cylinder (2) and lightly
push down. Kneel on the seat to hold it together. This will
press the base, pneumatic cylinder and seat together.
(Underside of the seat is shown in Figure 2)
6) On the chair back bar, depress the spring loaded button
with your finger, lift the back release. (DO NOT PUSH THE
BAR ALL THE WAY THROUGH AT THIS TIME.)
7) Now, push the bar down until it protrudes at least 1” below
the channel. (You should hear the spring-loaded button click
open as it comes out the bottom of the channel). Adjust
the height of the seat back for comfort and push the back
release down to lock the bar in place.
8) Adjust the seat back to the desired angle using the control
lever located on the side of the seat. You can adjust the
height of the back by lifting the back release up. Push the
back release(9) down to lock the bar in place.
9) To raise the height of your chair, take your weight off of the
chair and pull up on the lever (8) on the underside of the
seat and adjust.
10) To lower the height of your chair you must be seated with
your weight on the seat, lift up on lever (8).
6
2
1
3
4
7
5
SEAT
BACK RELEASE
CASTERS/GLIDES
CENTER HOLE
OF SEAT
LEVER
CONTROL
PADDLE
FIGURE 2.
8
9
CSO-04
