Spectrum Mopit mini, Руководство оператора и сервисное руководство, Страница: 15 / 38

Page 15
MAINTENANCE / SERVICE
Brush Motor Replacement
On rare occasions the brush motor may need to be replaced. Please call Spec-
trum at 1-800-290-2833 to troubleshoot and see if your brush motor needs to
be replaced. The brush motor is equipped with an automatic thermal circuit
breaker. If the brush motor overheats the breaker will trip and will reset again
when the motor cools down.
You do not need to remove any of the plastic tanks for motor replacement. It
is easiest to replace the brush motor with the Mopit on its back.
You will need a 5/32, 1/8, and 3/16 Allen wrenches
1. Follow the steps on page 11 to remove the belt
2. Remove these four Allen bolts using a 5/32 Allen wrench
3. Pull the drive bearing plate off of the brush and then you can pull the motor
plate out as well
4. Remove the two motor screws using a 1/8 Allen wrench. Transfer the pul-
ley onto the new motor by loosening the pulley set screw.
5. Replacement is the above steps in reverse
6. HINTS: Make sure that the motor pulley is touching only the motor shaft,
not the mo-
tor base.
Make sure
that you
tighten the
set screws
onto the flat
of the motor
shaft.