Page 4
For technical questions, please call 1-888-866-5797.
Item 64823 64824
NOTICE
Clean the Spray Gun and Cup IMMEDIATELY after EVERY use and when it will be idle for more
than 30 minutes. Delayed or inadequate cleaning will permanently clog the Spray Gun.
DO NOT USE LATEX PAINT IN THIS SPRAY GUN.
S
AFETY
Op
ERA
TION
M
AINTENANCE
S
ET
up
Air Source
a.
Never connect to an air source that
is capable of exceeding 200 psi.
Over pressurizing the tool may cause
bursting, abnormal operation, breakage
of the tool or serious injury to persons.
Use only clean, dry, regulated compressed air at the
rated pressure or within the rated pressure range as
marked on the tool. Always verify prior to using the
tool that the air source has been adjusted to
the rated air pressure or within
the rated air-pressure range.
b.
Never use oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source
for the tool.
Such gases are capable of
explosion and serious injury to persons.
SAVE THESE INSTRuCTIONS.
Symbol Definitions
Symbol
property or Statement
pSI
Pounds per square inch of pressure
CFM
Cubic Feet per Minute flow
SCFM
Cubic Feet per Minute flow
at standard conditions
NpT
National pipe thread, tapered
NpS
National pipe thread, straight
Symbol
property or Statement
WARNING marking concerning
Risk of Eye Injury.
Wear ANSI-approved eye protection.
WARNING marking concerning
Risk of Respiratory Injury.
Wear NIOSH-approved respirator.
WARNING marking concerning
Risk of Explosion.
WARNING marking concerning Risk
of Fire.
Do not use solvents improperly.