Page 3
For technical questions, please call 1-888-866-5797.
Item 64823 64824
NOTICE
Clean the Spray Gun and Cup IMMEDIATELY after EVERY use and when it will be idle for more
than 30 minutes. Delayed or inadequate cleaning will permanently clog the Spray Gun.
DO NOT USE LATEX PAINT IN THIS SPRAY GUN.
S
AFETY
Op
ERA
TION
M
AINTENANCE
S
ET
up
personal Safety
a.
Stay alert. Watch what you are doing and
use common sense when operating the tool.
Do not use the tool while tired or under the
influence of drugs, alcohol, or medication.
A moment of inattention while operating the
tool increases the risk of injury to persons.
b.
Dress properly. Do not wear loose clothing
or jewelry. Contain long hair. Keep hair,
clothing, and gloves away from moving parts.
Loose clothes, jewelry, or long hair increases
the risk of injury to persons as a result
of being caught in moving parts.
c.
Do not overreach. Keep proper
footing and balance at all times.
Proper footing and balance enables better
control of the tool in unexpected situations.
d.
use safety equipment.
Wear protective paint spraying
gloves and a NIOSH-approved
respirator during use. Non-skid safety
shoes and a hard hat must be used for
the applicable conditions.
e.
Always wear eye protection.
Wear ANSI-approved safety goggles.
Tool use and Care
a.
Do not force the tool.
Use the correct tool for the
application. The correct tool will do the job better
and safer at the rate for which the tool is designed.
b.
Disconnect the tool from the air source before
making any adjustments, changing accessories,
or storing the tool.
Such preventive safety
measures reduce the risk of starting the tool
unintentionally. Turn off and detach the air supply,
safely discharge any residual air pressure, and
release the throttle and/or turn the switch to its
off position before leaving the work area.
c.
Store the tool when it is idle out of reach
of children and other untrained persons.
A tool is dangerous in the hands of untrained users.
d.
Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that affects the tool’s operation.
If damaged,
have the tool serviced before using. Many accidents
are caused by poorly maintained tools.
There is a risk of bursting if the tool is damaged.
e.
use only accessories that are identified by the
manufacturer for the specific tool model.
Use of
an accessory not intended for use with the specific
tool model, increases the risk of injury to persons.
Service
a.
Tool service must be performed only
by qualified repair personnel.
b.
When servicing a tool, use only identical
replacement parts. use only authorized parts.