To remove door:
1. Open door wide enough to be able to access the quick-release hinge.
2. Support door with one hand.
3. With other hand, push-down on the quick-release hinge lever until the upper hinge pin clears the upper hinge pin hole.
Figure 3A
.
4. Hold the quick-release hinge lever down while tipping the top of the door away from the lectern.
5. Release the quick-release lever and lift the door up and away from lectern to remove the lower hinge pin from the lower hinge pin hole.
6. Place the door in a safe location so it does not get damaged.
0116157R1 Page 4 of 12
Quick-release door hinge operation
Door alignment procedure:
If the door appears to be misaligned, a slight adjustment can be made to the bottom
hinge-side of the door.
Figure 3B
.
1. Using the quick-release lever, remove the door.
2. Set the removed door on a non-abrasive worksurface.
3. Slightly loosen the nylon locknut on the bottom corner of the door with a 3/8” or
adjustable wrench and Phillips screwdriver.
4. Reposition the locknut and screw on the bottom of the door as required:
A. Move nut and screw away from the handle-side of the door to raise the
handle-side of the door.
B. Move nut and screw toward the handle-side of the door to lower the handle-
side of the door.
5. After adjustment, be sure the locknut is tightened securely.
6. Reinstall door and check alignment.
7. Repeat this procedure if necessary.
Figure 3A
Figure 3
Figure 3B
upper hinge pin
lower hinge
pin hole
lower
hinge pin
removable
acrylic panels
door
To re-attach door:
1. Place the lower hinge pin into the lower hinge pin hole.
Figure 3
.
2. Push down on the quick-release hinge lever until it reaches its lowest position and hold.
3. Align the upper hinge pin to the upper hinge pin hole.
4. Release the quick-release hinge lever.
5. The door now is attached and can be opened and closed normally.
lower
hinge pin
to lower
handle-side
of door
to raise
handle-side
of door
bottom of
door
quick-release
lever
lower hinge
pin hole
