0192314 Page 3 of 5
4. Attach divider at seam
4. Attach divider at seam
Adder(s) and row of connected desks required - (skip to step 5 if no adders)
Adder(s) and row of connected desks required - (skip to step 5 if no adders)
1. Locate the seam between two desks.
2. From under the worksurfaces, remove the existing unit-to-unit
bracket and (4) screws.
Figure 4.1
.
3. Place the 0159149 bracket against the worksurface with the bend
pointing downward, and re-install the unit-to-unit bracket with the
removed screws.
4. Attach the 0159150 bracket to the 0159149 bracket with (2) #8 x 3/8”
PHSM screws.
Figure 4.1
(1) 0159150
Bracket
(1) 0159149
Bracket
Existing
unit-to-unit
Bracket
(4) Existing
#14 x 7/8”
PHSM screws
(2) #8 x 3/8”
PHSM
Worksurface #1
Worksurface #2
Seam between
two desks
5. Apply one tape disk to the right side of the 0159150 and 0159166
brackets. Press and hold to each bracket for 30 seconds to secure.
Figure 4.2
.
6. Insert the side divider tabs into the desk #2 rear divider slots and
push down slightly to lock into place.
7. With the side divider level with the worksurface, press and hold to the
0159150 bracket tape for 30 seconds to secure.
8. Install the 0159166 bracket into the upper rear divider slot of desk #1,
and press and hold to the side divider for 30 seconds to secure.
Note: Repeat this step for each additional desk using adder components.
Figure 4.2
Side divider
Tape disk
Tape disk
(1) 0159166
Bracket
2
1
3
Desk #1
Desk #2
(1) 0159150
Bracket
Press
here
Press
here
