0192314 Page 2 of 5
Figure 1
Rear divider
1. Attach 0159148 bracket to worksurface
1. Attach 0159148 bracket to worksurface
1. Attach the bracket to the left side of the worksurface with (2) #14 x
7/8” PHM screws as shown.
Figure 1
.
0159148
Bracket
(2) #14 x 7/8”
PHSM screws
Figure 2
2. Attach rear divider
2. Attach rear divider
1. Loosen the (2) chair rail screws and pull the chair rail away from the
desk about 1/4”.
Figure 2
.
2. Set the rear divider notches over the chair rail screws in between the
chair rail and leg frames.
3. Retighten the chair rail screws to secure the divider. (Do not
overtighten screws.)
Worksurface
Figure 3
3. Attach left side divider
3. Attach left side divider
1. Apply one tape disk to the left-side of the bracket. Press and hold to
the bracket for 30 seconds to secure.
Figure 3
.
2. Insert the left side divider tabs into the rear divider slots and push
down slightly to lock into place.
3. With the left side divider level with the worksurface, press and hold to
the tape for 30 seconds to secure.
Side divider
Tape disk
Press
here
Worksurface
