0114246R1 Page 7 of 12
9. Install the two adjustable shelves at the desired height and attach to the side panels with (4) 1/4-20 x 5/8” PHM
screws and tighten securely.
Figure 2D
. Use the lowest set of mounting holes when installing the lower shelf.
10. Attach the door to the corner column (opposite the door bracket) with (5) 8-32 x 1/2” PH thread-cutting screws.
Be careful not to overtighten these screws.
11. Install (3) 2” grommets in the top panel.
Figure 2D
1/4-20 x 5/8” PHMS
(4 per shelf)
door
8-32 x 1/2” PH
thread-cutting screws
(5 req’d)
Note:
At this point, if you are using the optional floor brackets, place the pedestal into its final location,
adjust the brackets to contact the floor and tighten securely. Mark the bracket hole locations onto the floor.
These hole locations will be used with anchor fasteners compatible with your specific floor. (Not included.)
2” grommet
(3 req’d in solid
top panel only)
door
bracket
corner
column
top panel
(solid shown)
Note:
If you will be attaching the pedestal riser, install the door, but not the shelves, then proceed with the
pedestal riser assembly instructions on p.8.
Note:
Spectrum recommends using the low-
est set of mounting holes when installing the
lower shelf to maximize pedestal stability.
