0118408 Page 3 of 16
Figure 3.2
(2) 1/4-20
x 15mm JC
bolts
(4) 1/4-20 x 40mm
JC bolts
1. Determine which side of the lectern the equipment rack is to be installed (left
or right side). (Right-side installation shown.)
2. Attach the unit-to-unit brackets to the equipment rack side panel mounting
holes with (4) 1/4-20 x 15mm JC bolts.
Figure 3.1
.
Figure 3.1
Unit-to-Unit bracket
(2) 1/4-20 x
15mm JC bolts
Unit-to-Unit bracket
Lectern
Equipment Rack with
installed unit-to-unit
brackets
3. Bring the equipment rack to the lectern and align the unit-to-unit
brackets with the mounting holes in the lectern leg.
4. Install (4) 1/4-20 x 40mm JC bolts through the top of the
lectern leg and tighten securely.
Figure 3.2
.
Equipment Rack
Lectern leg
4
mm
Note: The flip-up shelf option may not be included with all configurations.
The shelf is designed for use on Freedom One eLift equipment racks that
are attached to the lectern with unit-to-unit connectors. The shelf installs
on the equipment rack side opposite the Freedom One Lectern.
Figure 4.2
Figure 4.1
Folding shelf
bracket
Release lever
(press here)
1.
Determine which side of the equipment rack you want the shelf installed.
(Left or right).
2.
Extend each shelf bracket by depressing the release lever and lifting
until it locks into the 90° position.
Figure 4.1
.
3. Using a second person to support the shelf, install the (8) 8-32 x 1/2” PH
thread-cutting screws into the side panel. Do not tighten until all screws
have been installed.
4.
Tighten all screws securely.
5. Install 2” grommet.
Equipment Rack
Flip-up shelf
assembly
2” Grommet
8-32 x 1/2” PH
thread-cutting screws
(4 per bracket)
CAUTION
Keep clear of pinch points during shelf movement. Do not exceed 35 lb
[15.9 kg] of weight on shelf.
Not for use on stand-alone equipment racks.
Operation
The shelf will automatically lock into place when lifted into the horizontal
position with the levers released.
Figure 4.2
. To lower or flip-up the shelf,
press and hold the shelf bracket levers while slowly lowering or raising the
shelf. Do not move the lectern while the shelf is in the horizontal position.
Note: Power and communication wiring for document cameras, laptop
computers, and / or projectors placed on the flip-up shelf should be routed
on top of the audience-side of the shelf. Use of the shelf grommet hole for
wiring will result in pinching of the cords when the shelf is folded.
Installing flip-up shelf
(optional)
3. Connect lectern and equipment rack
