2. Attach equipment rack casters / glides
0118408 Page 2 of 16
CAUTION
Keep clear of pinch points during worksurface movement. Note: The lift
actuators provide 540 lb of lift.
Always unplug the lectern before working under the worksurface.
Do not place anything under the worksurface when operating lift.
Although this lectern utilizes an anti-collision feature that briefly stops
and reverses the worksurface motion in the event of an obstruction,
use caution when raising or lowering.
Do not
sit at, under, or on the
worksurface when operating the lift mechanism and be sure lectern
movement does not interfere with objects or people.
Use caution when
raising or lowering the worksurface
!
Control buttons
Down
Up
Note: The lectern has a load-sensing, anti-collision feature programmed
into the controller that actively locks out the lift mechanisms when
unbalanced loads are encountered; i.e. an obstruction under the work-
surface, or weight from a person sitting on one side of the lectern.
1.
On a non-abrasive surface, carefully tip the equipment rack onto its back or side.
2.
Install the included stem casters or glides and tighten securely.
Note: 2 locking casters should be installed on the instructor-side for easy-access.
3. Tip the equipment rack back upright.
Figure 2.2
Locking stem
caster
for casters
Stem caster
Instructor side
Audience side
Glide
3
/
4”
5
/
8”
for glides
Figure 1.2
Figure 2.1
Note: This unit is not designed for use with cord reels or surface-mount
cord reel accessories.
1. Lectern lift mechanism initial setup, operation, and reset procedure
Assembly / Setup
Preparation:
• Read all instructions before operation.
• Make sure lectern is plugged-in using the 15-foot, 15-amp power cord.
• Locate the “Up” and “Down” control buttons. Control pad is located on the instructor-
side under the worksurface front edge on opposite side from rack cabinet.
• Keep clear of pinch points during worksurface movement.
Normal Operation:
To raise or lower the lectern, press and hold the “up” or “down” arrow keys on the control
pad until the worksurface reaches the desired height. The worksurface can be adjusted
from 28.5”H
(minimum)
to 42”H
(maximum)
.
Figure 1.1
