0107821R5 Page 4 of 10
4. Monitor installation
1.
Attach the VESA mount (butterfly-shaped portion) to the back of your
flat panel monitor with (4) M4 x 12mm PHM screws. (Holes on top,
slots on bottom).
Figure 4A
. Note: On most flat panel monitors, it
will be necessary to remove the standard base that comes with the
monitor to use the VESA mounting option.
2. Thread (2) 10-24 x 1/2” SHC screws into the upper rectangular plate
at the back of the VESA mount-leave about 1/8” between the screw
head and plate.
Figure 4A
upper 10-24 x 1/2” SHCS
(2 required)
back of monitor
M4 x 12mm PHMS
(4 required)
VESA mount
(with holes on top,
slots on bottom)
3. Align the attached VESA mount with the lift column slots and insert
the upper pair of 10-24 SHC screws through the slots using the
access holes provided near the center of the slots.
Figure 4B
.
4. Slide the monitor assembly downward, then install the lower pair of
10-24 SHC screws through the slots.
5. Locate the monitor assembly at the desired height on the lift column
then tighten all (4) 10-24 SHC screws. If the monitor is located near
the very top of the column, leave a small gap between the top of the
monitor and lift bracket to provide enough clearance for the monitor to
fully tilt. The gap distance needed will vary with monitor size.
Figure 4B
lower 10-24 x 1/2” SHCS
(2 required)
lift column
gap
monitor
assembly
slot access holes
in lift column
Phillips
screwdriver
Tools Required
4mm hex
wrench
VESA mount
