057943R5 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2016 Spectrum Industries Inc., All rights reserved.
2. Attach Brackets to Desks
1. Remove the existing front 1/4-20 x 1-3/4” PHM screw that attach the leg to the worksurface.
2. Position Z-brackets as shown in
Figure 2
. (The elongated hole in the Z-bracket will attach to the corner
connector.) Attach the rear Z-bracket to the leg using a 1/4-20 x 5/8” PHM screw as shown in
Figure 2
,
attach the front Z-bracket with the existing 1/4-20 x 1-3/4” PHM screw. Tighten completely.
3. Install a #8 x 3/4” Tek screw through each Z-bracket using an electric drill with a phillips head driver.
Note: This is a self-drilling screw-no pilot hole is required. If your drill has a torque setting, set it to
medium and tighten the screw securely, but be careful not to strip-out the hole while tightening the screw.
4. Repeat this procedure for the opposite side.
3. Attach Corner Connector to Desks
1. Align both desks 90° to each other leaving about 14” between the corners as shown in
Figure 3
.
2. Place the Corner Connector onto the Z-brackets and align the mounting holes.
3. Attach with (4) 1/4-20 x 5/8” PHM screws, but do not tighten completely-after the screws are
started, alignment of the desks may be necessary.
4. After alignment is satisfactory, tighten all screws.
#8 x 3/4” PH TEK screw
#8 x 3/4” PH TEK screw
Figure 2
Corner connector
24”D Evolution desk
24”D Evolution desk
Figure 3
Flip section open
Z-bracket
1/4-20 x 5/8” PHMS
Leg
Z-bracket
Existing 1/4-20 x 1-3/4”
PHMS
Front of desk
Cord channel
