rear unit-to-unit
bracket
057859R6 Page 3 of 4
3. Attach chair rail
1. Carefully stand the desk upright-this will require at least two people.
2. Attach the chair rail with (2) 1/4-20 x 2” FHM screws as shown.
Figure 3.
The chair rail should extend above the worksurface, and the countersunk
holes should be on the outside.
3.
For 60” & 72” desks only: Using the 3rd flat head screw, attach the
center of the chair rail to the chair rail bracket. (The chair rail bracket
may require slight adjustment for proper alignment).
4. Tighten all screws securely.
Note: If you are assembling a 60 or 72” desk, attach the center of the
chair rail to the chair rail bracket using the 3rd flat head screw.
(The chair rail bracket may require slight adjustment to align properly.)
Figure 3
Figure 4
4. Attaching desks together (optional)
Two desks can be attached together with (2) of the included unit-to-unit brackets and
(2) 1/4-20 x 5/8” PHM screws.
Figure 4
.
1.
Locate the desks next to each other in their final position.
2. Attach one of the unit-to-unit brackets to the back of the legs with (2) 1/4-20 x 5/8”
PHM screws and tighten securely.
3. To attach the front unit-to-unit bracket to the legs, unscrew the existing front leg
screws enough to slide in the bracket, then re-tighten the screws.
1/4-20 x 2” FHMS
(2 required)
for 60”, and 72”
desks only
chair
rail
front unit-to-
unit bracket
desk #1
desk #2
1/4-20 x 5/8” PHMS
(2 per bracket)
